CAUTION:Read and follow all Safety Rules and Operating Instructions Before Every Use of this Product.SAVE THESE INSTRUCTIONS.Sears, Roebuck and Co., H
• 8 •PARTS9. The Sears service centers offer the following replacement parts for your battery charger. If you are having trouble with your battery cha
• 9 •FEATURES 10. ASSEMBLY INSTRUCTIONS11. It is important to fully assemble your charger before use. Follow these instructions for assembly:PARTS TOO
• 10 •To attach the axle assembly:11.1 Remove charger from packing materials and place upside down on a at surface. Attach mounting foot and secure w
• 11 •Place the charger on its side. Place one end of each bracket into slot, then 11.3 place the axle assembly under each bracket. Fasten the other s
• 12 •OPERATING INSTRUCTIONS12. SETTING THE CONTROLS12.1 All controls for your charger are located on the front of the unit. Follow these instructions
• 13 •The 2 amp charge rate may not indicate activity on the meter. The meter does not have the resolution to display this low rate.CALCULATING CHARGE
• 14 •The Hydrometer or Electronic Method13.2 To nd the time needed to fully charge your battery, determine the bat-tery’s charge level with a hydrom
• 15 •USING THE ENGINE START FEATURE14. Your battery charger can be used to jump-start your car if the battery is low. Follow these instructions on ho
• 16 •TROUBLESHOOTING17. PROBLEM POSSIBLE CAUSE SOLUTION/REASONSNo reading on the am-meter.Clamps are not making a good connection.2-amp charge rate i
• 17 •PROBLEM POSSIBLE CAUSE SOLUTION/REASONSAmmeter reads less than selected charge rate when charging a discharged battery.Extension cord too long o
TABLE OF CONTENTSSECTION PAGE1. IMPORTANT SAFETY INSTRUCTIONS 12. PERSONAL PRECAUTIONS 23. PREPARING TO CHARGE 34. CHARGER LOCATION 3
• 18 •
• 1 •IMPORTANT: READ AND SAVE THIS SAFETY AND INSTRUCTION MANUAL.IMPORTANT SAFETY INSTRUCTIONS1. SAVE THESE INSTRUCTIONS - The DieHard model 71230 Man
• 2 •WARNING – RISK OF EXPLOSIVE GASES.WORKING IN THE VICINITY OF A LEAD-ACID BATTERY IS DANGER-OUS. BATTERIES GENERATE EXPLOSIVE GASES DURING NOR-MAL
• 3 •PREPARING TO CHARGE3. If it is necessary to remove the battery from the vehicle to charge it, al-3.1 ways remove the grounded terminal from the b
• 4 •FOLLOW THESE STEPS WHEN BATTERY IS INSTALLED IN 6. VEHICLE. A SPARK NEAR THE BATTERY MAY CAUSE A BATTERY EXPLO-SION. TO REDUCE THE RISK OF A SPAR
• 5 •FOLLOW THESE STEPS WHEN BATTERY IS OUTSIDE VEHICLE. 7. A SPARK NEAR THE BATTERY MAY CAUSE A BATTERY EXPLO-SION. TO REDUCE THE RISK OF A SPARK NEA
• 6 •BATTERY CHARGING - AC CONNECTIONS8. For all grounded cord-connected battery chargers: 8.1 GROUNDING AND AC POWER CORD CONNECTION INSTRUCTIONS • –
• 7 •Recommended minimum AWG size for extension cords for battery 8.3 chargers:25 50 100 150(7.6) (15.2) (30.5) (45.6)0 2 18 18 18 162 3 18 18 16 143
Kommentare zu diesen Handbüchern